Shoptalkforums.com

I have been in the process of doing a complete frame up off the pan restoration on my 1974 standard beetle. Thus far I've got roughly half of the finish removed right down to the bare metal. Unlike sandblasting, I accomplished this by using aircraft industrial grade paint remover. My question : is there any need to worry or be concerned about that product leaving any kind of a residue that could possibly hinder the adhesion quality of the primer & paint that will be applied? Any tips & advice would be appreceated. Thanks.

Fran

I don't think it leaves a residue. I've used it before with pretty good success and no adhesion problems thereafter.

My only tip to you would be once your done, wash, wash, and wash again. Make sure you get all of that stuff off.

JC - ATL
When you say wash, wash, wash, what kind of washing solution are you refering to? You're not suggesting water and soap are you? And if so, won't that make the metal rust? Instead of washing could I achieve good results by simply sanding the bare metal with the proper grit sand paper before applying the first primer coat?

Fran

Actually, I am referring to good old soap and water, lots of it. Of course, you want to get everything dry afterwards as well - chamois or towel followed by air compressor drying. That brief amount of water exposure won't promote rust if you dry it afterward.

They do make a metal prep for paint remover. I highly suggest you use such a product. I'll check and see who makes mine. You might not want to sand blast until you prep the metal.

What is the name of this aircraft industrial grade paint remover? And where did you get it? Please let me know.

Thanks,

Chris

Chris, if it's similar to the one I've used it's called "Aircraft Paint Remover." I know that sounds like I'm pulling your chain, but that's actually what it's called. Your local paint jobber will have them.

Is this from the same folks who made(make?) strip-ez? Zip-Srip?
Auto body panel shop here carries something like it.
I use a razor blade(4") from Home -depot in a holder to remove the gunk. Think the blade was in the wall paper department??
The blade can be used with curtting edge out or duller edge out.
Don't think you'll cut the metal either way!
FWIW DaveP

you can get it at Auto Zone. its over by the paint and bondo and stuff. its a can that says "Aircraft Remover" on it and has a picture of a 747 plane. i was walking by it one time and this old man says "damn! thats powerful stuff!" i once dipped a diecast toy car in it, and i pulled it out and it was bare metal, stripped the paint off to the max!

Powerful is an understatement! Use it in a WELL VENTILATED area, wear thick rubber gloves (maybe the kind for dishwashing since they cover some arm too). Do NOT get it on your skin! The stuff works like magic, but commands some "respect".

wash all bare metal with metal conditioner and dry with a clean towel.just prior to priming. Metal conditioner is available at your auto paint supply shop.