Page 1 of 1
Camshaft lifters
Posted: Wed Jan 14, 2004 5:50 pm
by Trike Rider
I plan to run a WebCam, their lifters are a bit expensive anyone run any other kind without trouble?
Dennis
Posted: Wed Jan 14, 2004 6:37 pm
by Dave_Darling
Well, LN Engineering's ceramic lifters have a very good rep. Much more expensive than the Web ones.
There are several other lifter manufacturers out there. Some people have used all of them and had them work just fine. Others have had the lifters go bad and eat the cam. Ya pays yer money and ya takes yer chances....
--DD
Posted: Fri Jan 16, 2004 3:16 pm
by lmcchesney
What about Web Cam lifters and then Cryo them?
Any data, because I know there are a lot of opinions? It would be very inexpensive.
L. McChesney
Posted: Sat Jan 17, 2004 9:47 pm
by 73notch
cb performance lifters, 40 bucks for lightweight lifters, i heard they are the 2 piece design like the webcam lifters, just way cheaper. they also have cams. i havent used them yet though.
Posted: Sun Jan 18, 2004 7:39 am
by MASSIVE TYPE IV
The CB lifters are a one piece design and weigh 135 grams!
The Web Cam lifters are nowdays far from my favorite choice.
It got so scary here with the topic that I had to swap to Ceramics 100%
Posted: Sun Jan 18, 2004 6:34 pm
by 73notch
i remember dstar said they were a 2 piece design. maybe the "non lightweight" ones are one piece? here is a good post on em.
http://www.shoptalkforums.com/viewtopic ... highlight=
Posted: Sun Jan 18, 2004 6:36 pm
by Trike Rider
Yes I checked out the CB lifters and am going to use them ,good price good quality and have them and the cam Cyro'd i think that is the good path to take
Dennis
Posted: Sun Jan 18, 2004 9:48 pm
I have the NOS lifters made way back in 1985, Steve
Posted: Mon Jan 19, 2004 7:06 pm
by Trike Rider
Just found out today CB Performance no longer carries the lightweight lifters. Dennis
Posted: Tue Jan 20, 2004 4:33 pm
by 73notch
Why not
Posted: Tue Jan 20, 2004 5:53 pm
by Trike Rider
Theres no more on their shelves.
Posted: Mon Jan 26, 2004 2:50 pm
by lmcchesney
I'm being offered a set of Johnson lifters. I have had difficulty finding complete information on the net regarding their use in the 914 engine. Does anyone have good informaiton regarding their use, quality, price and lognivity?
Thanks,
L. McChesney
Posted: Mon Jan 26, 2004 3:48 pm
by MASSIVE TYPE IV
GET THEM!!!
Posted: Tue Jan 27, 2004 1:17 pm
by 73notch
"buy now"
Posted: Sat Jan 31, 2004 12:35 am
by Piledriver
"Get Pictures first, post here. Make sure they ARE real Johnsons"
Use search...
Or just get the reground/polished/parkerized ones from Aircooled.net, (these are NOT used, just precision reground to Johns specs)
John stands behind his stuff.
I _Strongly_ suggest getting cam/lifters/oil pump from him, he will replace them all if required _if_ bought from him and the cam dies)
Ceramics are cheap insurance if your time is worth _anything_.
Go that way and get on with life.