COme on Build my 2332 for me here are the parts !!

dgluyas · Post by **dgluyas** » Mon Oct 27, 2003 4:51 am

Ok You have a new set of 044 cnc heads , 44x37 with big beef matched manifolds, you have a set of 94mm barrels and pistons, engle 140 cam and 1.25 rockers from CB. The motor is for fun not longevity. So come on what compression would you run???What kind of power do you think it would make ??

mharney · Post by **mharney** » Mon Oct 27, 2003 8:48 am

I will give you as much detail as I can given what detail you gave.

Compression: high
Power: lots (maybe).

Guest · Post by **Guest** » Mon Oct 27, 2003 10:33 am

Dude I have a 2332 with nearly the same specs,, but scat 1.25 rockers. and the engle 130 cam. We built it for desert racing and longevity. CR calculated came out the 9.65:1, we were shooting for 9.5:1
Power comes on at about 1800 and pulls loke a D9 cat all the way to 6000 or more. I cut the revs at 6400.
can you say,,,,Torque_monster!!!!!

Guest · Post by **Guest** » Mon Oct 27, 2003 10:35 am

Anonymous wrote:Dude I have a 2332 with nearly the same specs,, but scat 1.25 rockers. and the engle 130 cam. We built it for desert racing and longevity. CR calculated came out the 9.65:1, we were shooting for 9.5:1
Power comes on at about 1800 and pulls loke a D9 cat all the way to 6000 or more. I cut the revs at 6400.
can you say,,,,Torque_monster!!!!!

we are also runnning duals 44 idf's,,, we cloned this motor off a 2332 that produced 168 hp at the flywheel but with a single 48 ida.

We fugure 175-190 hp?????