Page 1 of 1
..
Posted: Sat Jun 08, 2002 9:15 pm
by 1967Fastback
..
typ4 into type3 dell manifolds.
Posted: Sun Jun 09, 2002 12:45 am
by njv
hello
hi there csp here in germany sell them and they stand at 4in tall ive got a set for my t4 into t3 i do wish they were only 3- 3 1/2 in tall as it standfs its gonna be so tight with my air filter tops right up against my engine lid still thats probably how its gonna be.
may be worth getting a cheap set of normal size manifolds and getting them cut and welded as you will get them real short then,
beszt of luck.
------------------
neil verdon 1966 t3 sqr on irs pan.
typ4 into type3 dell manifolds.
Posted: Sun Jun 09, 2002 3:09 pm
by 1967Fastback
..
typ4 into type3 dell manifolds.
Posted: Sun Jun 09, 2002 4:07 pm
by MASSIVE TYPE IV
Buy the CB manifolds and ship them to FAT, Greg can shorten them for you.....
I made my own jig for doing it, it takes a bit of time to get totally right..
------------------
Jake Raby
Raby's Aircooled Technology
www.aircooledtechnology.com
typ4 into type3 dell manifolds.
Posted: Mon Jun 10, 2002 6:37 pm
by 1967Fastback
..
typ4 into type3 dell manifolds.
Posted: Sun Aug 04, 2002 7:14 pm
by 1967Fastback
..
typ4 into type3 dell manifolds.
Posted: Sun Aug 04, 2002 7:17 pm
by Guest
I had a set done by Fat Performance and the cost was somewhere around $150. Need to buy a set of TYpe IV manifolds from CB Performance as Jake had said and then ship to Fat Performance for the rest.
I will have a full write up on this very thing soon in VWT. Thanks to Greg at Fat Performance.