Page 1 of 1
MAT Air Density Table and MAT/CLT correction table
Posted: Tue Sep 01, 2015 10:37 am
by thedrew
Can I get someone to post their MAT Air Density Table and MAT/CLT correction tables?
I'm noticing when the air is cold my setup runs terribly rich. I haven't touched the stock tables, so if someone else has made them work I'd love to save the hassle of figuring it out
Thanks!
Re: MAT Air Density Table and MAT/CLT correction table
Posted: Sun Sep 06, 2015 8:32 am
by mads b (dk)
The air density is a seintific messure. try to move your mat sensor to better location
Samsung S5
Re: MAT Air Density Table and MAT/CLT correction table
Posted: Sun Sep 06, 2015 2:38 pm
by thedrew
What about the MAT/CLT correction table?
Mines all zero'ed out
Re: MAT Air Density Table and MAT/CLT correction table
Posted: Wed Sep 09, 2015 12:16 pm
by paradox_pete
How sure are you of your injector settings (dead time / flow)? I think if these are not accurate it will result in the mixture changes you are reporting (dead time in particular I think). I think this is in the documentation somewhere (or possibly in the MSExtra forums). I was seeing similar issues, but getting more accurate injector settings resolved it.
-Pete
Re: MAT Air Density Table and MAT/CLT correction table
Posted: Wed Sep 09, 2015 1:04 pm
by thedrew
I believe I got this somewhat sorted out.
I am using ITB mode and I had not updated my the ITB switchpoint curve. On startup my idle valve opens all the way up and with the way the ITB load was calculated it would be high up in the VE table and run terribly rich.
Slowly getting a handle on this thing I feel like.... onto the next problem!