Mounting a second baro?

[Max Welton]

I just posted this over at

http://www.msextra.com/forums/viewtopic ... 01&t=45568

... but I either have to get this done tonight or button it back up and put it back in the car without the 2nd baro.

===

I have an MPX4250AP-WS, a V3.57M SMD MB, and some 1K resistors.

I have read the little section at http://www.megamanual.com/ms2/install.htm#baro, but am still a little lost.

Which pin on the sensor is #1?
Where are the "proto area", JS5, SG and S5 locations on the MB?



These MB pictures are fairly large...

http://www.maxwelton2k.net/squareback68 ... G_7386.jpg
http://www.maxwelton2k.net/squareback68 ... G_7389.jpg
http://www.maxwelton2k.net/squareback68 ... G_7393.jpg

Max

[supaninja]

You can mount it wherever you want, just add some jumper wires.

[Max Welton]

Well, sure. But I don't know where the wires go.

Max

[supaninja]

You got a MS1 v3.0 right? http://msextra.com/doc/ms1extra/MS_Extr ... tm#conbaro

[Max Welton]

Nope, MS2 V3.57 SMB. The SymTech guy on msextra set me straight.

http://www.msextra.com/forums/viewtopic ... 80#p326080

http://www.msextra.com/doc/ms2extra/MS2 ... m#layout35

Max

[Max Welton]

Anybody got some tips on really fine soldering?

http://www.maxwelton2k.net/squareback68 ... G_7395.jpg

Max

[Steve Arndt]

There are many soldering guides online. Check / google "smt soldering" guides. You aren't doing surface mount technology w that through hole sensor, but the prep work and methods apply.