Page 1 of 1
STD Pistons
Posted: Sat Mar 21, 2009 10:53 pm
by Flagbuggy
Hi all am planning a 2.1 turbo if the std pistons get machined down and ceramic coated what boost levels can they take
Posted: Sun Mar 22, 2009 2:03 am
by WBX Man
Search for "Marco" and "turbo" in this forum...
I think it was 21 psi on stock components, and arround 260 HP with small modifications to rods
Posted: Sun Mar 22, 2009 3:59 am
by fastback
which engine ?
from the DJ 10.5:1
or the MV/SS engine ~9.0:1 ? ?
Posted: Sun Mar 22, 2009 8:56 am
by WBX Man
Posted: Sun Mar 22, 2009 1:49 pm
by Flagbuggy
Hi thanks WBX for those links man these turbo motors can make horses
Just had a look at the 1.9 Turbo Cosworth pistons I got the deckheight is the same as a std 2.1 so will need slight modifications on them to get the right CR
Posted: Wed Mar 25, 2009 2:06 pm
by buildabiggerboxer
Flagbuggy wrote:Hi thanks WBX for those links man these turbo motors can make horses
Just had a look at the 1.9 Turbo Cosworth pistons I got the deckheight is the same as a std 2.1 so will need slight modifications on them to get the right CR
how about the compression height on the cossie pistons?
Posted: Wed Mar 25, 2009 11:53 pm
by Flagbuggy
Compression height
are youtalking from the top of the piston to the pin hole or the dish inside the piston
