Cheap head work
Posted: Sat May 31, 2008 3:02 pm
This should probably be posted in the forced induction section too because it has a turbo, anyhoo enjoy:
Thanks for posting that, I needed a good laugh!!Page 1 of 1
Posted: Mon Jun 02, 2008 1:03 pm
ROFLMAO Some folks will believe ANYTHING!!! Thanks for posting that, I needed a good laugh!!
Thanks for posting that, I needed a good laugh!!Posted: Thu Jun 05, 2008 9:22 pm
Posted: Thu Jun 05, 2008 9:35 pm
Good grief.
It is either a joke or one of the most conceptually misguided plans of all time.
It is either a joke or one of the most conceptually misguided plans of all time.
Posted: Fri Jun 06, 2008 7:27 am
I remember following the thread down a while back, unfortunately the poor slob sounded real enough to be true.jrandy wrote:Good grief.
It is either a joke or one of the most conceptually misguided plans of all time.
Posted: Fri Jul 04, 2008 3:25 am
reminds me of a post on a computer forum i used to visit... he wanted to water cool his computer, so he sealed it up with silicone, and poured water in the case! and as far as we all know he was serious...posted pics n all!
I love people!
I love people!
Posted: Tue Jul 08, 2008 8:55 am
This is similar to that extrude hone crap.
Yes...you can port a head this way....but you have absoluetly no control over where material is removed...or even if what an abrasive paste, liquid or putty will follow a dynamic path anything similar to what the path of least resistance might be for airflow.
The people who subscribe to this are teh same that think big and smooth is the only meaning of porting. They also think that the bigger the TB the better.
Many times...well planned dinky little ports and TB's can outflow massive hogged out TB's and ports.
I have seen a porting done (illegal of course) on Nascar and grand national engines wherin material was actually added in in select places....for best flow at a certain rpm ..to occour. Ray
Yes...you can port a head this way....but you have absoluetly no control over where material is removed...or even if what an abrasive paste, liquid or putty will follow a dynamic path anything similar to what the path of least resistance might be for airflow.
The people who subscribe to this are teh same that think big and smooth is the only meaning of porting. They also think that the bigger the TB the better.
Many times...well planned dinky little ports and TB's can outflow massive hogged out TB's and ports.
I have seen a porting done (illegal of course) on Nascar and grand national engines wherin material was actually added in in select places....for best flow at a certain rpm ..to occour. Ray
Posted: Fri Jul 18, 2008 3:15 pm
What happened to common sense, these days it doesn't exist.
Posted: Fri Jul 18, 2008 10:19 pm
do you have link of that post?? must have fun to read it...sinistervw wrote:reminds me of a post on a computer forum i used to visit... he wanted to water cool his computer, so he sealed it up with silicone, and poured water in the case! and as far as we all know he was serious...posted pics n all!
I love people!
Posted: Thu Jan 01, 2009 11:09 pm
Its uncommon. Rocky66 deluxe wrote:What happened to common sense, these days it doesn't exist.