Shoptalkforums.com

Posted: **Fri Feb 16, 2007 12:16 pm**

Who's welds out doors using the backhand heat reflective pad? I cup the stinger to block the wind. What do you do, put up sheets of plywood?

https://weldingsupply.securesites.com/c ... ICK*SEARCH

Posted: **Fri Feb 16, 2007 9:07 pm**

I just swear like a sailor, and svoid welding in the wind. It's a pain to swap out the wire just to weld out of the garage, so I try not to do it.

Posted: **Sat Feb 17, 2007 7:37 am**

I don't change wire i use the mix out doors. I don't use the outershield fluxcore wire at all. If it's too windy it will be stick welded.

Mig welding outside without flux core wire.