IRS vs IRS Conversion?

ck85abc · Post by **ck85abc** » Tue Oct 31, 2006 8:53 pm

I'm just wonding if there is any disadvantages to using a swing to IRC conversion in a dune-buggy vs using an origional IRS?

jowlz · Post by **jowlz** » Tue Oct 31, 2006 9:34 pm

None. Nope. Nada.

MNAirHead · Post by **MNAirHead** » Wed Nov 01, 2006 3:47 am

You need a good quality jig to put the pivots in... plus it takes a couple hours of additional work.

Post by **Leatherneck** » Wed Nov 01, 2006 5:16 am

No should not be problem at all and while you are cutting and welding put an adjuster in the rear too.

MNAirHead · Post by **MNAirHead** » Wed Nov 01, 2006 9:00 am

the kids I'm donating parts to this year are puttingin adjusters RIGHT NOW with my jig... can take pix if you like...

Biggest issues with the conversion are...

1-chopping too much off the frame horns.. then having to refab
2-using a cheap jig

Post by **Leatherneck** » Wed Nov 01, 2006 10:14 am

Old article when the mag produced something worth buying.

Remember this is not for your VW off-road purist.

ck85abc · Post by **ck85abc** » Wed Nov 01, 2006 4:19 pm

MNAirHead wrote:the kids I'm donating parts to this year are puttingin adjusters RIGHT NOW with my jig... can take pix if you like...

Biggest issues with the conversion are...

1-chopping too much off the frame horns.. then having to refab
2-using a cheap jig

Pics would be nice.

Thanks everyone for the comments.

MNAirHead · Post by **MNAirHead** » Wed Nov 01, 2006 11:25 pm

PM me with your email address... I'll send a pix pack.. I don't have time to coordinate pix on a webserver.

Post by **Marc** » Thu Nov 02, 2006 8:01 am

Leatherneck wrote:Old article when the mag produced something worth buying....

Still the same standards of technical/proofreading excellence, though (the negative got flipped on the first photo).

jowlz · Post by **jowlz** » Thu Nov 02, 2006 10:28 am

I used my arms as the jig...Never thought much about it..but it might be why I have no toe or camber issues like some of the people who have used the 3x3 beanie boy arms. My arms are nice and straight and sit just about dead center in adjustment. Plenty of room to go each way...

Post by **Leatherneck** » Thu Nov 02, 2006 10:42 am

I have never done them but was wondering why you could not use the trailing arms. Now I know you can.

MNAirHead · Post by **MNAirHead** » Thu Nov 02, 2006 11:06 am

Arm placement is adjustable for alignment... this is not advised..

the jig normally attaches to the torsion housing... not spring plates..

Look at your oval mounting holes...

I've done it... was lucky.. then screwed up the next one.