Page 2 of 2
Re: Slick motorcycle ITB mounts for IDF manifolds
Posted: Sun Jun 10, 2018 2:23 pm
by djb
Can anyone confirm the year range for the Honda VFR800 TB's? The ones I am finding on Ebay do not look like the images posted in this thread.
Also would if someone could confirm the part number of the Mikuni adapters?
Thanks!
David
Re: Slick motorcycle ITB mounts for IDF manifolds
Posted: Sun Jun 10, 2018 11:34 pm
by TZepeSH
You are looking for 99-01 throttle bodies. About the rubber boots, I can not confirm. I milled the IDF manifolds such that the throttle bodies go in by 10mm, and used an O-ring to seal. And some little steel plates to fix the throttle bodies down. Sorry no pictures now.
Re: Slick motorcycle ITB mounts for IDF manifolds
Posted: Wed Jun 13, 2018 1:15 am
by TZepeSH
Here is my install. What kind of filters do you plan to use? The IDF K&N type will hit the fuel rail and the air holes are mis-aligned by maybe 10mm. I think that a 20mm spacer would solve the problem I also want to use the original velocity stacks.
viewtopic.php?f=1&t=138151&sid=cfe8c2b3 ... &start=180
Re: Slick motorcycle ITB mounts for IDF manifolds
Posted: Mon Sep 09, 2019 2:02 pm
by chickensoup
where is that trigger wheel and cps from?
thanks
Re: Slick motorcycle ITB mounts for IDF manifolds
Posted: Mon Sep 23, 2019 4:10 am
by TZepeSH
Trigger wheel is from Mario (thedubshop) and the CPS is from CB Performance (because Mario did not have one in stock when I bought the trigger wheel).