steering gear mounting clamp orientation

germansupplyscott · Post by **germansupplyscott** » Tue Apr 22, 2003 7:46 am

thingers,

i am remounting the steering gearbox on my thing after restoring the front end. in the manual i have (haynes beetle/ghia) it refers to the steering gearbox clamp having two orientations, one for beetle and one for ghia. the bracket has markings "13" and "14" on it.

which one points forward on a thing, "13" or "14"?

scott lyons

Post by **Marc** » Tue Apr 22, 2003 9:07 am

Good question, since a Thing is basically a `Ghia pan - I don't recall but I'd be willing to bet it goes on in the "Beetle" position, since the Thing steering column/wheel don't mount as low as in the `Ghia. It'll be obvious if it's wrong, the steering box input shaft won't be in line with the column.

germansupplyscott · Post by **germansupplyscott** » Tue Apr 22, 2003 10:57 am

marc,

the vehicle is not assembled yet, so i have no way to check the column to box alignment. i can attach the gearbox at a later time, but it is so much easier to do it all now.

scott lyons

Post by **Marc** » Tue Apr 22, 2003 11:06 am

punkinfair wrote:...the vehicle is not assembled yet, so i have no way to check the column to box alignment...

Oh. I'm pretty certain it needs to be in the "Beetle" (higher) position so that's where I'd put it unless someone who knows otherwise comes forward.

germansupplyscott · Post by **germansupplyscott** » Tue Apr 22, 2003 11:13 am

marc,

that makes sense to me.

scott lyons