electronic ignition

meangreen351 · Post by **meangreen351** » Thu Jan 09, 2003 7:14 pm

I was told when converting to elec ign to go with pertronix only. I was just wondering how hard it is to change to elec ign? thanks again

Crash · Post by **Crash** » Thu Jan 09, 2003 7:56 pm

remove the old points, screw in the electronic as per the instructions, connect it to the coil and go for a drive. Takes about ten minutes if you read very slowly.

-Mark

------------------
Blind Chicken Racing
www.blindchickenracing.com

vicsvw · Post by **vicsvw** » Fri Jan 10, 2003 4:27 pm

We have Used & Sold three different types and found a big difference in price and no difference in performance or Quility. If you don't read the instructions you can have proplems with any. We use the cheap ones and have never had a bad one, but have replaced all three types that have been hooked up wrong. See this page & the links -> http://www.1800vw.bizhosting.com/electronicing.htm

mlrailguy · Post by **mlrailguy** » Fri Jan 10, 2003 7:59 pm

All the guys in Moses Lake run Pertronics 1
None of us have ever had any problems. A must for any off roader.