Centermount DCNF?

Tristessa · Post by **Tristessa** » Thu Feb 22, 2001 10:24 pm

I picked up an engine recently that has a centermount Weber DCNF on it ... I'd never heard of something like this before, and asking around, neither has anyone else in the area. Anyone have any information or opinions about one of these?

Fred T. Cat · Post by **Fred T. Cat** » Fri Feb 23, 2001 8:13 pm

I just looked in my Weber carburator book. It does show that Weber Conversion kit # K305 for a VW Type1 dual port, did come with a Weber DCNF. Go to http://www.redlineweber.com/ & you should be able to e-mail them for some info on your setup.

Fred T. Cat
71 Super Beetle

[This message has been edited by Fred T. Cat (edited 02-23-2001).]

grumpybug · Post by **grumpybug** » Fri Mar 09, 2001 6:40 am

Anyone have good or bad results with a single 44 idf mounted on a 1700cc (88's) engine? Id like the simplicity of a single with performance equaling a set of kadrons at least until i feel like the headaches of strapping the duals back on. Motor has 34 ict's on it now and sounds like its trying to suck the air cleaners through the carbs. They gotta go. next choice would be a set of kadrons, but i have the 44 single lying around so want to know if it will run ok.

Fred T. Cat · Post by **Fred T. Cat** » Fri Mar 09, 2001 10:36 am

There is alot of good info on different setups for carbs at: http://www.aircooled.net/gnrlsite/resource/articles.htm