Could this engine block take 4.5 psi of boost?

With Turbo and Super charging you can create massive horsepower with vw motors.

How much boost could it take?

0 psi
0
No votes
3-5 psi
0
No votes
5-7 psi
1
25%
7-9 psi
0
No votes
9-11 psi
3
75%
 
Total votes: 4

Skodawaggarn
Posts: 5
Joined: Sat Jul 25, 2020 5:38 am

Could this engine block take 4.5 psi of boost?

Post by Skodawaggarn »

Hello! This is my first post here. I have an old Skoda Fabia 1.2 l (vw engine: azq) and I'm thinking of giving it a modest boost with the amr500 supercharger but I am unsure how much it can take as I'm not sure it's ever been done before. Judging from the pictures of the block and con rods, how much do you think would be reasonable? What is the maximum it could take? Do I have to reinforce it, etc?

Feel free to vote and elaborate!

Pics are from Google
You do not have the required permissions to view the files attached to this post.
madmike
Posts: 3146
Joined: Mon Jul 24, 2006 3:11 pm

Re: Could this engine block take 4.5 psi of boost?

Post by madmike »

It looks like it can take double that and then some :lol: nice thick cylinder walls and a rod with some 'meat' on it , check out a stock 1600 air cooled rod :wink: some of these 'Nut' on here are boosting to 30+ pounds :lol:
Skodawaggarn
Posts: 5
Joined: Sat Jul 25, 2020 5:38 am

Re: Could this engine block take 4.5 psi of boost?

Post by Skodawaggarn »

Thanks for the reply man! Yeah those look much weaker indeed. 😳 Awesome that people run those kind of pressures! Will def be checking some of that out. For my car then I guess other things than the engine itself would be the limiting factor... Good to know!
User avatar
Schweg
Posts: 1141
Joined: Sun Feb 04, 2018 1:48 pm

Re: Could this engine block take 4.5 psi of boost?

Post by Schweg »

It should hold, how ever your tuning both fuel and ignition will be critical if your running high boost.
User avatar
buguy
Posts: 6209
Joined: Wed Jan 26, 2005 8:53 pm

Re: Could this engine block take 4.5 psi of boost?

Post by buguy »

That would be a lot of work for not much gain. Tuned well, every 15 psi of boost doubles the hp. So at 4.5 psi your only going to gain 1/4 of the hp.
Skodawaggarn
Posts: 5
Joined: Sat Jul 25, 2020 5:38 am

Re: Could this engine block take 4.5 psi of boost?

Post by Skodawaggarn »

buguy wrote: Mon Jul 27, 2020 1:53 pm That would be a lot of work for not much gain. Tuned well, every 15 psi of boost doubles the hp. So at 4.5 psi your only going to gain 1/4 of the hp.
I don't know, 25-30% is a pretty good increase for a few hundred dollars. If I were to boost it up a lot I would probably have to change clutch, gearbox, driveshafts, diff, injectors, fuel pump, etc. That would be crazy expensive, so low-blowing it is not so bad for me I think.
Skodawaggarn
Posts: 5
Joined: Sat Jul 25, 2020 5:38 am

Re: Could this engine block take 4.5 psi of boost?

Post by Skodawaggarn »

Schweg wrote: Mon Jul 27, 2020 11:59 am It should hold, how ever your tuning both fuel and ignition will be critical if your running high boost.
For sure! Though I've seen some people just slap on a 1:1 fuel pressure regulator and use the stock tune for low boost. What do you think about that? Is it feasible?
User avatar
Schweg
Posts: 1141
Joined: Sun Feb 04, 2018 1:48 pm

Re: Could this engine block take 4.5 psi of boost?

Post by Schweg »

Sure it’s feasible. Though as mentioned the gains your looking for may not be there with lower boost, and boost is super addictive.
Skodawaggarn
Posts: 5
Joined: Sat Jul 25, 2020 5:38 am

Re: Could this engine block take 4.5 psi of boost?

Post by Skodawaggarn »

Haha I bet it is! :)
Post Reply