Making a Mold?

Coils · Post by **Coils** » Sat Jun 19, 2004 6:18 am

Can anybody here point me in the right direction for info on making a mold out of an existing part?
I would like to remake some parts out of fiberglass but not to sure on where to start.

Jean Melim · Post by **Jean Melim** » Sat Jun 19, 2004 9:45 am

Hi

I think this link can help you...

http://www.hotrodder.com/32Blowpar/page10.html

best regards

Jean Melim

Shadowbug · Post by **Shadowbug** » Sat Jun 19, 2004 10:32 pm

check this site out

this guy is building a one off car, so he's got lots of info on plug building and mold making. his methods aren't really the best way to do things, but definatly easier if its your firs time.

Coils · Post by **Coils** » Mon Jun 21, 2004 6:47 am

Jean & Shadowbug thanks for the links but I should have been more clear on my post. I don't know squat about making a mold and need to know where is some idiot guides to doing this, whether it be web sites or books to buy. I need something that explains the fundamentals of this.
Thanks again. John

Capn Skully · Post by **Capn Skully** » Mon Jun 21, 2004 10:36 am

Go to http://www.fiberglast.com

Lot's of supplies and info about fiberglass, molds, mold making etc.

Where are you located? I have fiberglass classes from time to time and I am always looking for help.

Coils · Post by **Coils** » Sun Jun 27, 2004 9:00 pm

Skully thanks for the link. Lancaster is about 45 minutes east of Harrisburg and an hour or so west of Philadelphia.
I appreciate the offer but I think Loisiana is a little far of a drive from PA.