Turbo, small T4 and the stock cam,

MattKab · Post by **MattKab** » Mon Apr 21, 2008 1:47 pm

No worries, not long until summer!

Both turbine flanges are now bolted up. I'm going with Nordloc washers and cap head screws. Any suggestions what to use as an anti-sieze in the threads?

What is good for such extreme temp applications? Any suggestions?

Matt

Wally · Post by **Wally** » Mon Apr 21, 2008 2:37 pm

Very nice self-made stub pipes Matt!!

If you got yourself a GT28RS60, then I am jealous! That must be the best all round turbo around! Well done!!

MattKab · Post by **MattKab** » Mon Apr 21, 2008 4:22 pm

Thanks Wally,

They were very easy to make! ..wasted a great pair of F-pipes, 1.5" tube ovaled in a vice and the cast stock part lapped for the O-ring and blended to the new pipe before welding then polished smooth.

The 'bo I got is 739548-5 on this page exactly:

http://www.turbobygarrett.com/turbobyga ... 9548_1.htm

I still need to get a funky adjustable actuator, any ideas?

Really struggling to go beyond 2" with the exhaust tonight

The 7/16"-24 45deg flare tube nut for the oil feed was a swine to find.

arr_kid · Post by **arr_kid** » Tue Apr 22, 2008 10:40 am

MattKab wrote:Any suggestions what to use as an anti-sieze in the threads?

What is good for such extreme temp applications? Any suggestions?

Matt

This stuff any good?

Wally · Post by **Wally** » Tue Apr 22, 2008 1:30 pm

1200 Celcius!

Yeah, you would think that would be enough huh?

Dave_Darling · Post by **Dave_Darling** » Tue Apr 22, 2008 2:07 pm

+1200C sounds pretty good indeed!

I know Jake is fond of Milk of Magnesia for an anti-sieze; I'm not sure if it holds up well in those sorts of temperatures. I do recall him saying something about using it on some parts of the jet engines he used to work on...

--DD

MattKab · Post by **MattKab** » Tue Apr 22, 2008 4:11 pm

Wow indeed, that's that department in order! It's good how the ingredients tell you what is not in it

M8 Nordloc washers and Belzona, problem eliminated!

Good call on that, I'll look after it.

Didn't even see the garage today, could of done 4 hours on the 411, but just enjoyed the sunshine

jonas_linder · Post by **jonas_linder** » Thu Apr 24, 2008 12:54 pm

MattKab wrote:No worries, not long until summer!

Both turbine flanges are now bolted up. I'm going with Nordloc washers and cap head screws. Any suggestions what to use as an anti-sieze in the threads?

What is good for such extreme temp applications? Any suggestions?

Matt

I have used copperpaste with good result, I haven't used it for a long time though. Just go to your local hardware store and ask them for advice!

nordloc is a very nice!!!

We use it on the race car, before we had to fasten all bolts for the compressor each round, now we don't need to worry about them

Ohh.. and here is the race car.. a little off topic