CARBON SEAL
- petew
- Posts: 3920
- Joined: Sat Oct 07, 2006 4:05 pm
Re: CARBON SEAL
Well I'd hate for someone to learn the hard way like I did.
-
- Posts: 58
- Joined: Fri May 10, 2013 7:36 pm
Re: CARBON SEAL
Petew... 1.5mm = .059" and 1mm = .039". I take it your factory turbo was journal bearing.
- petew
- Posts: 3920
- Joined: Sat Oct 07, 2006 4:05 pm
-
- Posts: 58
- Joined: Fri May 10, 2013 7:36 pm
Re: CARBON SEAL
Oh.. okay, as long as turbo has adequate oil and oil drainage, you should get better spool characteristics instead of too much oil slowing spool and blowing past seals. All depends on each engine's oil pressure, oil volume and engine condition (blow-by).