usefull parts from a auto-stick
-
- Posts: 18
- Joined: Sat Jun 26, 2004 1:49 pm
usefull parts from a auto-stick
Are there any parts that can be used in a four speed, from a auto-stick?
-
- Posts: 7087
- Joined: Sat Oct 13, 2001 1:01 am
Lots of parts.
3-4 slider, 3-4 shift hub, 3-4 shift fork, 3rd and 4th gear, gear's bearings, pinion bearing, syncros, and the entire diff.
Second gear is slightly lower than a 4 speed's second; 2.25 compared to 2.06. You should save the mainshaft and 2nd gear idler. Berg will mate an autostick 2nd to a 4speed first gear to make a close ratio 1-2 mainshaft.
Also worth keeping is the hockey stick. With a couple of simple modifications it is the hockey stick used in a Berg 5
3-4 slider, 3-4 shift hub, 3-4 shift fork, 3rd and 4th gear, gear's bearings, pinion bearing, syncros, and the entire diff.
Second gear is slightly lower than a 4 speed's second; 2.25 compared to 2.06. You should save the mainshaft and 2nd gear idler. Berg will mate an autostick 2nd to a 4speed first gear to make a close ratio 1-2 mainshaft.
Also worth keeping is the hockey stick. With a couple of simple modifications it is the hockey stick used in a Berg 5
the auto stick came with two different pinion bearings the later style is the same as the type 1 manual. part# 113 311 219B and will index to the case with it's hex type sholder. the early style autostick pinion bearing does not have this feature. it is prevented from rotating by an extra long pan bolt this bolt also passes through a retaining clip for the pinion bearing retaing nut. so make sure you have the later one before you use it on a four speed.