Discuss VW transaxles and transmissions. Gearheads wanted!
5 posts • Page 1 of 1
- Posts: 16
- Joined: Sat Feb 28, 2009 9:21 pm
Hi Would there be any interest in the vw 2052 tool? I had it made for myself its precision CNC cut out of two pieces of 15mm thick tool steel bolted with two m8 bolts it clamps the nut very securely. Its very tough I'm sure it will not wear out and it will be last tool you will ever need for this job. The cost short run would be around 120GBP but will go down if I can get more done.
Last edited by grzesiek on Thu Mar 29, 2018 6:19 pm, edited 1 time in total.
- Posts: 115
- Joined: Sun Nov 17, 2013 9:42 pm
There's two of those nuts like that, some tools can work for both and others can't. Might consider confirming it works for both if you're going to advertise it for sale. I use a laser cut one that Prescott sold for a while and a beetle splined fourth gear for doing 091's. It was a fine tooth beetle gear that I just ground flat on one side so the vice holds it easy.
- Posts: 1689
- Joined: Sun Apr 28, 2002 3:01 am
- Location: Santa Cruz