Here is a couple of questions I have if you could please.
1 where do I find the trans code on this case I cleaned the case up a little with a scraper and wire brush found some #s but don't think I have the code
2 Is there any maintenance improvements or useful inspections that can be done by disassembling/removing either the nose cone or bell housing ?
3 I have read these models may not need a jig for reassembly Is this true ?
4 It came with a stock hydraulic slave cylinder Are these stock ones any good ? You would think they should be pretty stout and smooth. I have a working jamar slave cylinder that was set up for the 002 would you use the stocker or the Jamar slave cylinder
5 I will need to vent this case to prevent water /mud intrusion where is the best place for a vent Vent higher than expected water level and put a loop in it ?
That,s all I can think of right now here is some pics
Terry
here is numbers i found I don't think they are the right ones for clues on gearing any one care to guess ?
![Image](https://www.thesamba.com/vw/gallery/pix/1750582.jpg)
![Image](https://www.thesamba.com/vw/gallery/pix/1750584.jpg)
![Image](https://www.thesamba.com/vw/gallery/pix/1750586.jpg)
pics of inside bellhousing
![Image](https://www.thesamba.com/vw/gallery/pix/1750607.jpg)
![Image](https://www.thesamba.com/vw/gallery/pix/1750606.jpg)
![Image](https://www.thesamba.com/vw/gallery/pix/1750590.jpg)
side x side with 002 its a good bit stouter
![Image](https://www.thesamba.com/vw/gallery/pix/1750595.jpg)
![Image](https://www.thesamba.com/vw/gallery/pix/1750594.jpg)
![Image](https://www.thesamba.com/vw/gallery/pix/1750593.jpg)
10* rear mount details
![Image](https://www.thesamba.com/vw/gallery/pix/1750602.jpg)
![Image](https://www.thesamba.com/vw/gallery/pix/1750603.jpg)
![Image](https://www.thesamba.com/vw/gallery/pix/1750605.jpg)
Here is the front mount that I will have to alter. All in all I am real happy with the ease it slipped in to the Baja
![Image](https://www.thesamba.com/vw/gallery/pix/1750604.jpg)
The bits that would not fit between the frame horns
![Embarassed :oops:](./images/smilies/icon_redface.gif)
![Image](https://www.thesamba.com/vw/gallery/pix/1750601.jpg)
And finally the car its going into
![Image](https://www.thesamba.com/vw/gallery/pix/1584600.jpg)
![Image](https://www.thesamba.com/vw/gallery/pix/1584601.jpg)
Thanks for looking
Terry