Setting 0 lash manton pushrods
Posted: Mon Sep 18, 2006 6:52 am
Jake,
I have been doing my valve adjustments by tightening a particular valve until I can just spin the pushrod. Problem is my fat little fingers have a tough time getting in there to really tell if it is spinning or if I am just sliding on oil. Any good techniques for setting 0..
Thanks
I have been doing my valve adjustments by tightening a particular valve until I can just spin the pushrod. Problem is my fat little fingers have a tough time getting in there to really tell if it is spinning or if I am just sliding on oil. Any good techniques for setting 0..
Thanks