Head Question Jake/Len
-
- Posts: 275
- Joined: Wed Apr 09, 2003 12:07 am
Head Question Jake/Len
I have installed my 7424 heads and have noticed that there is a port on each head for a cht sensor. I have installed a sensor in both of them but will only have the #3 side one hooked to the guage the other is just a dummy plug. My question is what are the smaller holes on the other side of the manifold from the cht plug. They are about half the diameter but I am not sure what plugs into them. I am assuming I need to block them off. Thanks !
-
- Posts: 20132
- Joined: Fri Jul 07, 2000 12:01 am
DO NOT HOOK THE CHT THERMOCOUPLE TO THE STOCK CHT LOCATION!!!!!
Thats the worst location tom measure running temperature! I have proven this many times in direct testing.
The CHT thermocouple is designed to go UNDER THE SPARKPLUG and unless you do this the reading you get may be up to 150 dgegrees incorrect!
Thats the worst location tom measure running temperature! I have proven this many times in direct testing.
The CHT thermocouple is designed to go UNDER THE SPARKPLUG and unless you do this the reading you get may be up to 150 dgegrees incorrect!
-
- Posts: 275
- Joined: Wed Apr 09, 2003 12:07 am
-
- Posts: 20132
- Joined: Fri Jul 07, 2000 12:01 am
-
- Posts: 275
- Joined: Wed Apr 09, 2003 12:07 am
-
- Posts: 20132
- Joined: Fri Jul 07, 2000 12:01 am
-
- Posts: 275
- Joined: Wed Apr 09, 2003 12:07 am
-
- Posts: 275
- Joined: Wed Apr 09, 2003 12:07 am