Machining down lifter bores, how far?
-
subwoofer
- Posts: 85
- Joined: Sat Apr 02, 2011 12:14 pm
Re: Machining down lifter bores, how far?
I forked out for the Berg tool. Will press in the bushes before reaming.
Joachim
- Fia, '14 Fiesta Titanium
- Frk Jensen, '74 Jensen-Healey
- Kengu, '90 Caravelle C Syncro
Diesel is good for cleaning parts...
- Fia, '14 Fiesta Titanium
- Frk Jensen, '74 Jensen-Healey
- Kengu, '90 Caravelle C Syncro
Diesel is good for cleaning parts...
-
Arnoud
- Posts: 102
- Joined: Sun May 25, 2008 7:27 am
Re: Machining down lifter bores, how far?
Doesn't the height of the oilholes dictate the amount of material that has to be machined off?
At least that is what i did when i machined my case.
Regards,Arnoud
At least that is what i did when i machined my case.
Regards,Arnoud
-
AMBROSIA
- Posts: 248
- Joined: Wed Jul 27, 2005 5:37 am
Re: Machining down lifter bores, how far?
Depends on the lifter type.
Stock hydro lifters have a wide single oil groove.
Most T1 style have the two groove setup.
My Thorsten's have a single groove but considerably less than the Hydro lifter.
I requested my bushings to have enlarged oil holes to compensate.
Stock hydro lifters have a wide single oil groove.
Most T1 style have the two groove setup.
My Thorsten's have a single groove but considerably less than the Hydro lifter.
I requested my bushings to have enlarged oil holes to compensate.