thrust washer bore

Here's the place for info on converting to a Type V motor!
Post Reply
DRED
Posts: 33
Joined: Thu Jul 22, 2010 6:14 pm
Location: Normandie FRANCE
Contact:

thrust washer bore

Post by DRED » Thu Feb 19, 2015 4:40 pm

Hello,

Can someone help me an tell me the trust washer bore and depth in the 3 piece rear main Bearing engine case.
I'm trying to fit à wbx crank in a type 1 case with BMW bearings and want to use wbx thrust washers if it' possible.. i want tout know if the samedi housing is machinable. ...

User avatar
pocketrocket
Posts: 388
Joined: Sat Jan 04, 2003 3:01 am

Re: thrust washer bore

Post by pocketrocket » Sun Feb 22, 2015 5:40 pm

74mm x 1.7mm

DRED
Posts: 33
Joined: Thu Jul 22, 2010 6:14 pm
Location: Normandie FRANCE
Contact:

Re: thrust washer bore

Post by DRED » Sun Feb 22, 2015 7:12 pm

Thanks a lot pocketrocket..seems to be bigger than what i was expecting (the thrust set i have at home have 73,1/73,2mm diameter). i was worried about concentricity and having the more tight housing possible, to avoid "hula hoop" , but doesn't seems to be so important..

Post Reply