T1 Con rod info with Wasser pistons

Here's the place for info on converting to a Type V motor!
Post Reply
jackstraw
Posts: 126
Joined: Sat Oct 29, 2005 9:22 pm

T1 Con rod info with Wasser pistons

Post by jackstraw » Sat Oct 07, 2017 7:36 pm

Greetings. The pistons are floaters. The T1 has 22mm pins and the Wasser has 24mm pins. If I wanted to run a T1 rod it stands that the small end needs opened up for the larger pin.

Will I loose strength if this is done? I'm looking at a 5.5" rod to mimic what Vanistan used to use
I think this a rod that will work. Scat ICR5500-8740 VW JOURNAL 2.165"/55mm 5.500"/139.00mm

AMBROSIA
Posts: 239
Joined: Wed Jul 27, 2005 7:37 am

Re: T1 Con rod info with Wasser pistons

Post by AMBROSIA » Sun Oct 08, 2017 3:13 pm

I had a set of scat I beams machined to wbx size.
Image
Image

Yet to run them so I can't comment on strength, but I won't be pushing the rpm's as it's in a street application.

jackstraw
Posts: 126
Joined: Sat Oct 29, 2005 9:22 pm

Re: T1 Con rod info with Wasser pistons

Post by jackstraw » Sun Oct 08, 2017 3:34 pm

I grabbed these pic's from the samba. Wasser vs T1. Wasser small end definitely has more meat. Looks like two oil holes for pin.
T1 rod A bit smaller on the small end. Your pic looks like you only had to hone out some of the bushing . Seems doable then.
7431572.jpg
6524248.jpg
You do not have the required permissions to view the files attached to this post.

User avatar
Marc
Moderator
Posts: 23723
Joined: Thu May 23, 2002 2:01 am
Contact:

Re: T1 Con rod info with Wasser pistons

Post by Marc » Thu Oct 12, 2017 2:31 pm

For a given stroke (and of course, piston weight), longer rods will cause less stress on the wristpin and small end of the rod since the piston will approach & depart TDC at a slower rate. I'd be more leery of hogging out the rod if it were shorter than stock.

If you've ever wondered what the rod angle @90°is for a particular rodlength-to-stroke ratio, there's a formula at the bottom of this page: http://victorylibrary.com/mopar/rod-tech-c.htm

jackstraw
Posts: 126
Joined: Sat Oct 29, 2005 9:22 pm

Re: T1 Con rod info with Wasser pistons

Post by jackstraw » Mon Oct 16, 2017 9:21 pm

Thanks for the reply. I've always been partial to a longer rod to take advantage of a wee bit extra top and bottom dwell.

Scat wants $75 per rod to hone out for 24mm pins. Seems steep. Maybe they wrote me a typo .
I'll check the local machine shops.

Post Reply