Who is the best person to rebuild your engine? You...
2 posts • Page 1 of 1
- Posts: 90
- Joined: Thu May 08, 2014 10:51 am
- Location: Richmond, IN
If you have access to a TIG welder, you could weld a nut to the pin and hope it holds while you pry. There is another possibility - dowel pins over a certain size are only case hard. Grind the end of the pin to get through the case and then drill and tap it. You will know right away if it is too hard to tap when your drill won't get in there. Once you have this tapped hole, you can use a slide hammer.