Adjustment of Wipers?

flat4fantasy · Post by **flat4fantasy** » Thu Dec 26, 2002 10:07 am

I've got a '65 Notch and the right side (pass) wiper rests to far down, and thus hits the windshield seal when it comes down to it's lowest point.

I cannot adjust the wiper, because the wiper shafts have a little "divot" so the wiper centers exactly in this spot.

Any ideas?

Also anyone have a source for the windhsield spigot/washer seals and squirters.

Thanks,
Dave (L.A.)

Bobnotch · Post by **Bobnotch** » Thu Dec 26, 2002 1:01 pm

Well you could try removing the wiper arm, and filing a flat in the approximate spot that the arm will be going,the screw is long enuf to do this. You just kinda have to guesstimate this,as you're only going to move it a little bit. I did this on my 69 Square and it worked out pretty good. I hope this helps.

Bob 65 Notch S

Bobnotch · Post by **Bobnotch** » Thu Dec 26, 2002 1:04 pm

You can try West Coast Metric for the other parts, they should be the same as a bug. I hope this helps.

Bob 65 Notch