Speeduino ECU

Fuel Supply & Ignition Systems

Moderator: Tom Notch

User avatar
itawolf
Posts: 294
Joined: Thu Sep 02, 2010 8:07 pm
Location: vestavia alabama

Re: Speeduino ECU

Post by itawolf » Tue Jul 18, 2017 3:41 pm

that sucks bad

price wise it looked promising
RET Marine 0317 --with VW on the lobe!!
Lots of iron in the fire

User avatar
Piledriver
Moderator
Posts: 21786
Joined: Sat Feb 16, 2002 3:01 am
Location: Van Alstyne, Texas

Re: Speeduino ECU

Post by Piledriver » Tue Jul 18, 2017 5:40 pm

It still does, there's a V.5 board in the works that's ~all SMT and uses an automotive AMP connector.

Did they fix that routing issue on V.41 or .42 boards?
The bare boards are like $10 if you can DIY.

Properly done jumpers are not a cracking hazard, think SMT and wire wrap wire.
I, for one, regularly embrace our new robot overlords, as I am the guy fixing the robots...

User avatar
kangaboy
Posts: 745
Joined: Wed Jan 22, 2003 3:01 am
Location: St. Louis, MO

Re: Speeduino ECU

Post by kangaboy » Tue Aug 01, 2017 3:54 pm

So the only reason this has "hit a dead end" is because of a possible grounding issue? I'm still intruiged
'74 Standard- 1776T, MS3X3
'76 Westy- Stock 2.0L L-Jet

qaxa
Posts: 23
Joined: Fri Jul 21, 2017 2:34 pm

Re: Speeduino ECU

Post by qaxa » Wed Aug 02, 2017 1:34 am

https://speeduino.com/forum/

No it is not dead. I built one board earlier but it's not installed in a running engine yet. It does work however when I've tested it with a simulator.

cnicholls
Posts: 5
Joined: Mon Sep 19, 2016 10:13 am

Re: Speeduino ECU

Post by cnicholls » Thu Aug 17, 2017 9:47 am

I believe that the boards you purchase now are all fixed, I just happened to buy 4 boards with the flaw in it. Just don't order a version 0.4.1

Post Reply