Page 1 of 1

Type 4 billet head

Posted: Mon Mar 05, 2018 7:52 am
by -Alex77-
I am currently designing type 4 billet head. Most of the basic design work has been done, but valve-angle bothers me. I must re-measure it again because i am getting more than 10 degrees. I think lower angle would benefit the ports too.



Image

Re: Type 4 billet head

Posted: Mon Mar 26, 2018 2:01 pm
by Type 4 Unleashed
I forget if it's 11 or 13 degrees.

Re: Type 4 billet head

Posted: Tue Mar 27, 2018 4:06 pm
by Andy Somogyi
If you sell them at a reasonable price, and they provide better cooling than stock, I'll be the first in line to buy them.

If you're designing these from scratch, are you also modeling heat-flow?