Type 4 billet head

This is the place to discuss, or get help with any of your Type 4 questions.

Moderator: Type 4 Unleashed

Post Reply
-Alex77-
Posts: 205
Joined: Sun Feb 10, 2008 3:46 pm
Location: Finland, near north pole

Type 4 billet head

Post by -Alex77- » Mon Mar 05, 2018 7:52 am

I am currently designing type 4 billet head. Most of the basic design work has been done, but valve-angle bothers me. I must re-measure it again because i am getting more than 10 degrees. I think lower angle would benefit the ports too.



Image

User avatar
Type 4 Unleashed
Moderator
Posts: 2142
Joined: Wed Nov 09, 2005 1:43 am
Location: Aliso Viejo, CA

Re: Type 4 billet head

Post by Type 4 Unleashed » Mon Mar 26, 2018 2:01 pm

I forget if it's 11 or 13 degrees.
Richard

EMW

“Have you ever noticed how some people never
have the money to do it right, but can always
find the money to do it twice ?”

Andy Somogyi
Posts: 23
Joined: Wed Feb 14, 2018 12:25 pm
Location: Indiana, US

Re: Type 4 billet head

Post by Andy Somogyi » Tue Mar 27, 2018 4:06 pm

If you sell them at a reasonable price, and they provide better cooling than stock, I'll be the first in line to buy them.

If you're designing these from scratch, are you also modeling heat-flow?

Post Reply