Speedi-sleeve---part# for t4 flywheel seal?

This is the place to discuss, or get help with any of your Type 4 questions.

Moderator: Type 4 Unleashed

Post Reply
User avatar
Piledriver
Moderator
Posts: 21790
Joined: Sat Feb 16, 2002 3:01 am
Location: Van Alstyne, Texas

Speedi-sleeve---part# for t4 flywheel seal?

Post by Piledriver » Fri Jul 21, 2017 3:59 am

Have a good flex plate but a pretty deep groove in the seal surface...
Anyone know the part# offhand for a speedi-sleeve for a T4 flywheel seal surface repair?

(if not I'll post it up once I figure it out)
I, for one, regularly embrace our new robot overlords, as I am the guy fixing the robots...

User avatar
Udo Airbus
Posts: 126
Joined: Thu Oct 23, 2014 8:22 am

Re: Speedi-sleeve---part# for t4 flywheel seal?

Post by Udo Airbus » Fri Jul 21, 2017 7:07 am

I think you need to check whats availible at a webshop, and do some measurements:

Example: http://www.aandrijfshop.nl/skf-speedi-s ... ore=en&p=1

Good Idea, I need this for my caravan bearings :D
VW T1 1964 - Mouse Grey - Pearl White OG paint

Bagged, Porsche steeringrack/brakes..IRS, AMR Supercharged 1600 (sold) building a 1971cc EFI turbo/supercharged engine

User avatar
Piledriver
Moderator
Posts: 21790
Joined: Sat Feb 16, 2002 3:01 am
Location: Van Alstyne, Texas

Re: Speedi-sleeve---part# for t4 flywheel seal?

Post by Piledriver » Fri Jul 21, 2017 11:46 am

Can't seem to find a "new" or even worn seal surface spec in the Vanagon Bentley manual, need to know that as you can turn them down a little at least once to fix this, and going an extra .010" may cause issues if still original OD. I'll have to check a few flywheels later today to get a comparison...
I, for one, regularly embrace our new robot overlords, as I am the guy fixing the robots...

Bruce.m
Posts: 152
Joined: Sun Aug 11, 2013 3:44 pm

Re: Speedi-sleeve---part# for t4 flywheel seal?

Post by Bruce.m » Mon Jul 24, 2017 5:01 am

I like the SKF speedi sleeve. Need to slit the flange before fitting so it can be removed afterwards (twists off in a coil).

Post Reply