I have a question for y'all. I picked up a new to me Dtm kit but it's missing any instructions. It looks fairly straight forward but I can't seem to figure out how to get the bolts to go through the case on. Also, there's two little pieces of aluminum with a couple bolts. What are those for?
Thanks
DTM Install
- Piledriver
- Moderator
- Posts: 22518
- Joined: Sat Feb 16, 2002 12:01 am
Re: DTM Install
The folks at the type4store will probably be happy to provide instructions.
Without pictures we will only be guessing.
Without pictures we will only be guessing.
Addendum to Newtons first law:
zero vehicles on jackstands, square gets a fresh 090 and 1911, cabby gets a blower.
EZ3.6 Vanagon after that.(mounted, needs everything finished) then Creamsicle.
zero vehicles on jackstands, square gets a fresh 090 and 1911, cabby gets a blower.
EZ3.6 Vanagon after that.(mounted, needs everything finished) then Creamsicle.
- sideshow
- Posts: 3428
- Joined: Mon Oct 27, 2003 11:00 am
Re: DTM Install
The bracket is bolted to the case, then the dtm is bolted to that. The order is important as it really only goes one way.
Yeah some may call it overkill, but you can't have too much overkill.
-
- Posts: 15
- Joined: Thu Aug 13, 2015 10:38 am
Re: DTM Install
Thank you. That makes a lot of sense. The bracket bolts were loose and the others super tight so I wasn't sure if I was supposed to separate it or not.
- sideshow
- Posts: 3428
- Joined: Mon Oct 27, 2003 11:00 am
Re: DTM Install
I don't know why I didn't check here first;
http://www.aircooledtechnology.com/cooling/index2.shtml
http://www.aircooledtechnology.com/cooling/index2.shtml
Yeah some may call it overkill, but you can't have too much overkill.
-
- Posts: 15
- Joined: Thu Aug 13, 2015 10:38 am
Re: DTM Install
Thanks man,had no idea that site existed.